Signing and Delineation Unit (SDU) Procedures Manual

SectLink
Title : 01 INTRODUCTION ‎(5)
1.1 Purpose
1.2 How to Use the SDU Procedures Manual
1.3 Definitions and Acronyms
1.4 References
1.5 Contacts
Title : 02 PRINCIPALS ‎(7)
2.1 Introduction
2.2 Purpose of Signing and Delineation
2.3 Regulatory Traffic Control Devices
2.4 Warning Traffic Control Devices
2.5 Numbered Routes
2.6 Sign Messaging
2.7 Lane Continuity
Title : 03 PROJECT DELIVERY REQUIREMENTS ‎(9)
3.1 Introduction
3.2 PEF Prequalification Requirements
3.3 Project Timeline
3.4 Coordination Requirements
3.5 Quality Control Requirements
3.6 Submittal Requirements
3.7 Division Design Projects and SDU Coordination
3.8 SharePoint Application
3.9 NCDOT eSignature Procedures
Title : 04 SIGNING PLANS ‎(20)
4.1 Introduction
4.2 NCDOT Sign Types
4.3 Plan Elements
4.4 Title Sheet
4.5 Key Sheet
4.6 Ground Mounted Support Design
4.7 Overhead Sign Structure Drawings
4.8 Sign Designs, General
4.9 Type A and B Sign Panel Designs
4.10 Type D Panel Designs
4.11 Type E Signs (Regulatory and Warning Signs)
4.12 Type F Signs (Route Marker Assemblies)
4.13 Milemarkers (Reference Location Signs)
4.14 Overlay Designs and Placement Details
4.15 Supports for Types D, E and F Signs
4.16 Signing Plan Sheets
4.17 Existing Signing Plan Sheets
4.18 Proposed Signing Plan Sheets
4.19 Three-Person Check
4.20 Submittals
Title : 05 PAVEMENT MARKING AND DELINEATION PLANS ‎(21)
5.1 Introduction
5.2 Plan Elements
5.3 Title Sheet
5.4 Key Sheet
5.5 Pavement Marking Schedule, Legend and Symbols Sheet
5.6 Pavement Marking Details
5.7 Pavement Marking Plan Sheets
5.8 Field Investigations
5.9 Pavement Marking Design (Linework)
5.10 Pavement Marking Types
5.11 Stop Bars (Lines)
5.12 Yield Bars (Lines)
5.13 Curb Ramps and Crosswalks
5.14 Balloon Symbol Callouts
5.15 Stationing
5.16 Lane and Paved Shoulder Widths
5.17 Raised Pavement Markers
5.18 Delineators
5.19 Object Markers
5.20 Permanent Work Zone Traffic Control Devices
5.21 Submittals
Title : 06 REVISIONS ‎(5)
6.1 Revisions
6.2 Time Frames
6.3 Ground Mounted ‘S’ Dimension Field Verification
6.4 Overhead ‘S’ Dimension And Slope Field Verification
6.5 Correction Procedure For All Revisions

06 REVISIONS

6.4 Overhead ‘S’ Dimension And Slope Field Verification

Overhead structural line drawing 'S' dimensions are verified on every project. Follow the correction procedure outlined below. If there are no changes made on the Overheads, the sheets must still be sent out with a note on the plan sheet saying, “FIELD VERIFIED" without using the word “REVISED". Follow link to Determination of "S" Dimensions

Was this page helpful?

Privacy Statement |
Accessibility

Signing and Delineation Unit (SDU) Procedures Manual

06 REVISIONS

6.4 Overhead ‘S’ Dimension And Slope Field Verification

Was this page helpful?