​​
DISCIPLINE REQUIREMENTS


  
  
Description Of Work
  
  
  
  
AdditionalRequirements
Resources
  
Interchange Design126
Required for any projects that have interchanges in the scope of work.
Roadway EngineerP.E.P.E.
Must submit sample plans showing sufficient design capacity, including horizontal and vertical alignments with curve data, design information for intersections and interchanges, typical sections and cross sections. Statement of CADD capability – Microstation/Geopack Software is required, including names of CADD users/technicians.
Shannon Macon, 919 707-6274, slmacon@ncdot.gov
Rural Roadway Design201
Entry level for smaller and less complex projects, i.e. bridge replacement projects, safety projects and rural widening projects.
Roadway EngineerP.E.P.E.
Must submit sample plans showing sufficient design capacity, including horizontal and vertical alignments with curve data, design information for intersections and interchanges, typical sections and cross sections prepared within the last 5 years for NCDOT or similar agency that are dated and sealed.  Statement of CADD capability – Microstation/Geopack Software is required, including names of CADD users/technicians.​
Shannon Macon, 919 707-6274, slmacon@ncdot.gov
Urban Roadway Design269
More complex urban widening and new location projects with increased project impact restrictions due to dense residential and/or commercial development.
Roadway EngineerP.E.P.E.
Must submit sample plans showing sufficient design capacity, including horizontal and vertical alignments with curve data, design information for intersections and interchanges, typical sections and cross sections prepared within the last 5 years for NCDOT or similar agency that are dated and sealed.  Statement of CADD capability – Microstation/Geopack Software is required, including names of CADD users/technicians.​
Shannon Macon, 919 707-6274, slmacon@ncdot.gov
Roadway Lighting314
Roadway lighting layout design for fully controlled-access interchanges and for continuous sections between interchanges. Design utilizes a combination of high mast light standards, shoulder mount light standards, median mount light standards, underpass lighting if needed, light control and circuitry to meet the AASHTO lighting requirements.
Roadway EngineerP.E.P.E.
Must meet the “Necessary Expertise” stated in the AASHTO Roadway Lighting Design Guide, dated October 2018.  Must submit sample of work, including lighting construction plans, corresponding lighting photometric plans using lighting design software and sample voltage drop calculation for circuit design.​ Must submit two(2) sample Roadway Lighting Plans prepared within the last 5 years for NCDOT or similar agency that are dated and sealed.
Shannon Macon, 919 707-6274, slmacon@ncdot.gov
Low Impact Division Managed Roadway Design467
Entry level design for smaller and less complex projects, i.e. bridge replacement projects, safety projects and rural widening projects advertised at the Division level.
Roadway EngineerP.E.P.E.
Must submit sample plans showing sufficient design capability including horizontal and vertical alignments with curve data, design information for intersections and interchanges, typical sections and cross sections prepared within the last 5 years for NCDOT or similar agency that are dated and sealed. Statement of CADD capability including software type and names with experience level of CADD users/technicians is required. Firms without Microstation/Geopack capability will be limited to Division let projects. Firms with Microstation/Geopack capability will be qualified for Division projects that are centrally let out of Raleigh. ​
Shannon Macon, 919 707-6274, slmacon@ncdot.gov
Was this page helpful?